use an oscilloscope

[laimone]

OSCILLOSCOPE


This diagram shows a square wave trace on the screen of an oscilloscope.
The Y-sensitivity of the oscilloscope is set at 1.0V per division and the time base is set at 10.0ms per division.
1) For the trace, measure this tension.
2) Determine its frequency.
3) Measure its maximum value.
4) Draw what you get with these following settings:
a) 2V/div and 10ms/div
b) 1V/div and 20ms/div
c) 2V/div and 20ms/div
5) What are the best settings? Justify.
6) Explain that we can qualify the tension as alternating and periodic.
7) Draw the diagram on which we see the same tension with a non-activated scanning.

[Célestine]

Bonjour et merci pour le partage.

Peux-tu également poster ton document au format pdf pour ceux qui n'utilisent pas Ms Office ?

Célestine.